Anything and everything GT6.

Since the image feature is disabled this is going to be difficult, but here goes:

I have purchased a RH base foam for my GT6 MkIII drivers side seat. However, it doesn't appear to fit well into the wire seat basket I took out from the driver's seat. After looking at some photos I sent, the supplier says I have a LH(passenger) side seat basket. The wire basket has a shallow step one side and much deeper step on the other. In my case when the basket is viewed front to rear(i.e. where it meets the seat back) the deep step is on the sill side. This deep step ends up in a sort of wire ledge that extends over the sill. The RH seat foam suppiled has a deep step on the gearbox side.

I have found though that my original LH seat base does fit neatly in the drivers side seat frame. So, the supplier is probably right but I could do with another opinion.

Kevin