Home
> GT6 > Gearbox > Gearbox tunnel
Anything and everything GT6.
Section : Gearbox
Clutch, gearbox, overdrive, propeller shaft.
Posted By : Simon Dinsdale, 02-Apr-2006,
12:17pm
Just removed the fiberglass gearbox tunnel from my GT6 Mk2 to get access to the gearbox and the tunnel which I bought 17 years ago and never really fitted
properly split. Can anybody recomment a suppler of a new gearbox tunnel that actuall fits propely. Not particually bothered what it is made off, but where
the originals a pressed hardboard/ cardboard?
Thanks
Simon Dinsdale
-
Posted By : Andy Duck, 02-Apr-2006,
08:04pm
I'm in need of similar, for my Vitesse (same problem, old fibreglass one given up the ghost), i remember seeing really great looking "pvc" ones at
shows a few years back, but they dont sem to be around any more?
Andy
-
Posted By : Van Hamlin, 02-Apr-2006,
09:01pm
I bought a fibreglass one from Quiller Triumph.
I had to trim it a bit where it joins the bulkhead but otherwise it fits quite well. I glued a foam rubber seal about 3/8" x 1" all round the edge
and filled a couple of gaps with Homebase sealant after fitting the tunnel.
They come without holes in so you have to drill the holes for the mounting screws and cut the hole for the gear stick. I used a tank cutter and
then filed the extra out. It's quite easy to file.
Van
-
Posted By : Joe Grundy, 02-Apr-2006,
10:41pm
Sports Car Supplies in Gateshead, Tyne & Wear do them. Give Andy or Mike a call; 0191-496-0522.