Home
> GT6 > Gearbox > Twist In Clutch Pipework
Anything and everything GT6.
Section : Gearbox
Clutch, gearbox, overdrive, propeller shaft.
Posted By : James Dennison, 28-Mar-2006,
09:21pm
Just made up new pipework from clutch m/c taking the shortest and neatest route.
Looking in the catalogue it shows a couple of spiral "twists". What are these for?
Assuming these are essential (extra length = extra cost for BL) do I now need to make these up again an include a couple of twists?
Sure someone out there will put me straight!
James Dennison
(Staffs)
-
Posted By : Stephen Abbott, 28-Mar-2006,
09:32pm
James, the coil in the pipework is to allow for flexing as the engine can move slightly in relation to the bulkhead.
Steve.